I'm so close to completing my Basil project but I'm stuck because of the Adalogger FeatherWing & STEMMA Soil Sensor. They are both using the I2C bus...
I am unsure how to make these both work. From my research in I2C I can have multiple sensors connected but I have no clue where to go from here. One is using "board" the other "busio"
[component list] FeatherS2, Adalogger FeatherWing, STEMMA Soil Sensor. [/component list]
Code: Select all
i2c_bus = board.I2C()
ss = Seesaw(i2c_bus, addr=0x36)
myI2C = busio.I2C(board.SCL, board.SDA)
rtc = adafruit_pcf8523.PCF8523(myI2C)