0

Feather M0 Adalogger not responding to reset
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

Feather M0 Adalogger not responding to reset

by pforbes on Fri Feb 07, 2020 9:10 am

I tried installing CircuitPython on my M0 using Bossa but ran into some troubles finding the port number. After some fumbling around I discovered I could use the GUI and attempted to write CircuitPython using the .bin file. I got an error message (can't recall what it was) and tried restarting Bossa. Since then my computer does not recognize the M0 and pressing the reset button (1, 2 or 3 times) does not solve the problem.

If I carefully press the reset 1 time (for a specific amount of time), my computer will, for a split second, recognize the device (and the flashing red light on the M0 looks like it will start working) but then it immediately disappears.

The M0 LED continues to flash at approximately 1/sec.

Help!!

pforbes
 
Posts: 1
Joined: Fri Feb 07, 2020 9:05 am

Re: Feather M0 Adalogger not responding to reset

by adafruit_support_mike on Sun Feb 09, 2020 1:16 am

[moved to the CircuitPython forum]

adafruit_support_mike
 
Posts: 60735
Joined: Thu Feb 11, 2010 2:51 pm

Please be positive and constructive with your questions and comments.