Hi! I just upgraded to an M1 Mac & installed Mu. The CircuitPython in the lower left shows a red 'x' through it (see below), and while I can use "load" in Mu to load up code.py and can save to update code, I can't seem to open the serial monitor. Error also show. Any ideas? First thought is this is an M1 Mac issue - has anyone else used Mu successfully (or run into problems) on an M1 Mac?
Thanks!
Mu serial monitor not working on M1 Macs?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- gallaugher
- Posts: 267
- Joined: Tue Aug 14, 2018 12:42 pm
- tannewt
- Posts: 3304
- Joined: Thu Oct 06, 2016 8:48 pm
Re: Mu serial monitor not working on M1 Macs?
For folks that find this first.
From Neradoc on Discord:
From Neradoc on Discord:
until the next Mu beta, there's a potential solution here: https://github.com/mu-editor/mu/issues/ ... -848952043
- gallaugher
- Posts: 267
- Joined: Tue Aug 14, 2018 12:42 pm
Re: Mu serial monitor not working on M1 Macs?
Thanks a ton. Will try this out!
Please be positive and constructive with your questions and comments.