Hardware For Trellis 8x8 Enclosure

Please tell us which board you are using.
For CircuitPython issues, ask in the Adafruit CircuitPython forum.

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
BroMarduk
 
Posts: 32
Joined: Sun Jun 12, 2016 10:19 pm

Hardware For Trellis 8x8 Enclosure

Post by BroMarduk »

Hi,

A little over a year ago I ordered an 8x8 Trellis M4 kit. Just got around to putting it together and noticed I have the Feather, cable, pads, pad boards and all the acrylic pieces, but not the feet, nuts, screws, spacers, or standoffs. Not sure where they went, but this is most assuredly on my end. Searched the last few weeks for the orphans, but have not been able to find them.

I found the listing of parts but most of them are not in my parts inventory (I have some of the M2.5 black nylon nuts). Is it possible to buy another set of just the hardware or do I have to buy another enclosure? The only thing I found listed separately was the rubber feet...

4 x M3 black nylon spacers 15mm long
8 x M3 black nylon screws 8mm long
4 x M2.5 black nylon screws 10mm long
4 x M2.5 black nylon nuts
4 x M2.5 standoffs 3mm long (un-threaded)
1 x set of Little Rubber Bumper Feet (4 bumpers total).

Thanks!

User avatar
dastels
 
Posts: 15608
Joined: Tue Oct 20, 2015 3:22 pm

Re: Hardware For Trellis 8x8 Enclosure

Post by dastels »

You might be able to make do with https://www.adafruit.com/product/3299 and https://www.adafruit.com/product/4685, plus you'd have them for future projects.

Dave

User avatar
BroMarduk
 
Posts: 32
Joined: Sun Jun 12, 2016 10:19 pm

Re: Hardware For Trellis 8x8 Enclosure

Post by BroMarduk »

dastels wrote:You might be able to make do with https://www.adafruit.com/product/3299 and https://www.adafruit.com/product/4685, plus you'd have them for future projects.

Dave
True, and I would not mind the extras, but the only thing that those two kits have that are listed in the BOM for the enclosure is the 10mm 2.5 screws and nuts.

User avatar
dastels
 
Posts: 15608
Joined: Tue Oct 20, 2015 3:22 pm

Re: Hardware For Trellis 8x8 Enclosure

Post by dastels »

You could check ofthe places such as Digikey or Mouser. They tend to have a more extensive selection of generic parts.

Dave

User avatar
BroMarduk
 
Posts: 32
Joined: Sun Jun 12, 2016 10:19 pm

Re: Hardware For Trellis 8x8 Enclosure

Post by BroMarduk »

Thanks Dave,

That's the route I went. Next time, I'll have extras.

Best,

Dan

Locked
Please be positive and constructive with your questions and comments.

Return to “Itsy Bitsy Boards”