Com Port ejects while uploading
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- live4film
- Posts: 46
- Joined: Sat Nov 23, 2019 3:57 pm
Com Port ejects while uploading
I've been struggling with the gemma m0 for a while when uploading. I get it to work sometimes, but most of the time, I'll plug it in, check my device manager to confirm which com port is being used, and I select the correct board in IDE, and as it's uploading, my gemma m0 will just eject, or disappear, and sometimes it will disappear and then when the upload fails, the port shows back up again. I have 12 USB 3.0 ports that I've been trying. Some days I can upload, and other days I get upload port issues again. I reinstalled the drivers and I have the latest IDE, so I'm not sure why it's being so difficult.
- johnpark
- Posts: 985
- Joined: Wed Mar 25, 2009 2:15 pm
Re: Com Port ejects while uploading
Is this happening to you in MakeCode?
- live4film
- Posts: 46
- Joined: Sat Nov 23, 2019 3:57 pm
Re: Com Port ejects while uploading
No it's happening in the arduino IDE
- johnpark
- Posts: 985
- Joined: Wed Mar 25, 2009 2:15 pm
Re: Com Port ejects while uploading
OK, please post in the Arduino forum, thanks.
Please be positive and constructive with your questions and comments.