0

Com Port ejects while uploading
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

Com Port ejects while uploading

by live4film on Sat Feb 13, 2021 11:34 am

I've been struggling with the gemma m0 for a while when uploading. I get it to work sometimes, but most of the time, I'll plug it in, check my device manager to confirm which com port is being used, and I select the correct board in IDE, and as it's uploading, my gemma m0 will just eject, or disappear, and sometimes it will disappear and then when the upload fails, the port shows back up again. I have 12 USB 3.0 ports that I've been trying. Some days I can upload, and other days I get upload port issues again. I reinstalled the drivers and I have the latest IDE, so I'm not sure why it's being so difficult.

live4film
 
Posts: 46
Joined: Sat Nov 23, 2019 3:57 pm

Re: Com Port ejects while uploading

by johnpark on Tue Feb 16, 2021 1:08 pm

Is this happening to you in MakeCode?

johnpark
 
Posts: 881
Joined: Wed Mar 25, 2009 2:15 pm

Re: Com Port ejects while uploading

by live4film on Tue Feb 16, 2021 1:15 pm

No it's happening in the arduino IDE

live4film
 
Posts: 46
Joined: Sat Nov 23, 2019 3:57 pm

Re: Com Port ejects while uploading

by johnpark on Tue Feb 16, 2021 1:46 pm

OK, please post in the Arduino forum, thanks.

johnpark
 
Posts: 881
Joined: Wed Mar 25, 2009 2:15 pm

Please be positive and constructive with your questions and comments.