Com Port ejects while uploading

Microsoft's MakeCode platform for easy blocks-style programming

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
live4film
 
Posts: 46
Joined: Sat Nov 23, 2019 3:57 pm

Com Port ejects while uploading

Post by live4film »

I've been struggling with the gemma m0 for a while when uploading. I get it to work sometimes, but most of the time, I'll plug it in, check my device manager to confirm which com port is being used, and I select the correct board in IDE, and as it's uploading, my gemma m0 will just eject, or disappear, and sometimes it will disappear and then when the upload fails, the port shows back up again. I have 12 USB 3.0 ports that I've been trying. Some days I can upload, and other days I get upload port issues again. I reinstalled the drivers and I have the latest IDE, so I'm not sure why it's being so difficult.

User avatar
johnpark
 
Posts: 985
Joined: Wed Mar 25, 2009 2:15 pm

Re: Com Port ejects while uploading

Post by johnpark »

Is this happening to you in MakeCode?

User avatar
live4film
 
Posts: 46
Joined: Sat Nov 23, 2019 3:57 pm

Re: Com Port ejects while uploading

Post by live4film »

No it's happening in the arduino IDE

User avatar
johnpark
 
Posts: 985
Joined: Wed Mar 25, 2009 2:15 pm

Re: Com Port ejects while uploading

Post by johnpark »

OK, please post in the Arduino forum, thanks.

Locked
Please be positive and constructive with your questions and comments.

Return to “MakeCode”