Hello folks,
today I unboxed my brand-new CLUE controller board, but if I power it up the only thing is shown is a black screen and
on the backside a small red flashing LED and also the Neopixel LED steady red!
What are the next steps to get this unit started?
Any buttons I have to press?
Thanks for your support!
CLUE just showing black screen! Where to start?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- Dicsoft
- Posts: 1
- Joined: Sat Mar 14, 2020 10:48 am
- dastels
- Posts: 15820
- Joined: Tue Oct 20, 2015 3:22 pm
Re: CLUE just showing black screen! Where to start?
Read through https://learn.adafruit.com/adafruit-clue in detail if you haven't yet.
My next step would be to put a fresh version of CircuitPython (and libraries!) on it, see https://learn.adafruit.com/adafruit-clue/circuitpython.
See what happens then.
Dave
My next step would be to put a fresh version of CircuitPython (and libraries!) on it, see https://learn.adafruit.com/adafruit-clue/circuitpython.
See what happens then.
Dave
- adafruit_support_carter
- Posts: 29473
- Joined: Tue Nov 29, 2016 2:45 pm
Re: CLUE just showing black screen! Where to start?
There's also a quick and simple hardware test UF2 available here:
https://learn.adafruit.com/adafruit-clue/arduino-test
https://learn.adafruit.com/adafruit-clue/arduino-test
Please be positive and constructive with your questions and comments.