The display on my CLUE stopped working during my first project. There seems to be something wrong with the connection. I tried to reseat it in the connector, but that did not help. Part of the display starts working when I press on the connector. I made a video - https://www.dropbox.com/s/qf3a5jetw2hyd ... 6.MOV?dl=0.
Regards;
/jb
Faulty display
Moderators: adafruit_support_bill, adafruit
5 posts
• Page 1 of 1
Please be positive and constructive with your questions and comments.
From the video I see that the bottom display cable latch isn't seated (i.e. pushed all the way in). See if that helps.
Dave
Dave
-
dastels - Posts: 9796
- Joined: Tue Oct 20, 2015 3:22 pm
Yeah, it was odd, when I pushed that one in the other one pulls out. So I pulled both out, pulled out the flat cable and reseated it. Still same problem though.
Regards;
/jb
Regards;
/jb
-
bergdahl - Posts: 3
- Joined: Wed Apr 11, 2018 10:13 am
-
bergdahl - Posts: 3
- Joined: Wed Apr 11, 2018 10:13 am
OK, please email support@adafruit.com with a link to this thread, your order number, and request the replacement of one CLUE.
Dave
Dave
-
dastels - Posts: 9796
- Joined: Tue Oct 20, 2015 3:22 pm
5 posts
• Page 1 of 1
Please be positive and constructive with your questions and comments.