WipperSnapper and Adafruit AHT20 Moderators: adafruit_support_bill, adafruit

[bcarlson]

I've had an Adafruit ESP32-S2 Feather running WipperSnapper v1.0.0-beta.22 with an Adafruit AHT20 connect, to log temperature and humidity, it ran fine for a couple of weeks and then stopped uploading temperature and humidity updates, the ESP32-S2 Feather remained online. To troubleshoot I have removed the AHT20 component from the WipperSnapper board and removed the ESP32-S2 Feather as a WipperSnapper device and started all over adding the ESP32-S2 Feather back as a WipperSnapper device, the device showed online I then adding the AHT20 component. I then started the I2C scan, the scan completed and found address 0x38, with the temperature sensor and humidity sensor enabled I created the component. I got a green light on the AHT20 board and waited for over an hour and I still do not get temperature or humidity updates.

[michimac]

Glad to hear I am not alone. Identical issue. I loaded the arduino example code for the ADT20 and confirmed I was getting a reading from both temperature and humidity. Everything shows up as described on Wippersnapper, but no data.

[michimac]

https://www.adafruitstatus.com/ shows Error 525

[brubell]

Glad to hear I am not alone. Identical issue. I loaded the arduino example code for the ADT20 and confirmed I was getting a reading from both temperature and humidity. Everything shows up as described on Wippersnapper, but no data.

What were the periods your sensors were set to? Every 15 minutes? Could you try setting them to "Every 30 seconds"?

[michimac]

Done. Feather shows online. No data from sensor.

[redbishop]

Same issue on my end with the same hardware and firmware.

Screenshot 2022-01-26 171257.jpg (52.14 KiB) Viewed 92 times

[michimac]

Pretty sure it ain't us...

Capture3.PNG (45.4 KiB) Viewed 91 times

[michimac]

Now the server status seems fixed, but still no data.

[redbishop]

Yes, same here. Device is still listed as online but No Data Yet.

[nagrom78]

Same here no data showing up in my feed.

[brubell]

Yes, same here. Device is still listed as online but No Data Yet.

Same here no data showing up in my feed.

Now the server status seems fixed, but still no data.

Hi, this was a mistake on our end as we're working on adding more I2C sensors this week. It should be fixed now.

If you're still experiencing issues, please try deleting the sensor component and re-initializing it.

Thank you for reporting the issue and please let us know if it's working again for you.

[michimac]

Bingo. The data is flowing. Thank you!

[redbishop]

Ok for me as well. Thanks for fixing.

How do we find out when new I2C devices are available in WipperSnapper?

[brubell]

How do we find out when new I2C devices are available in WipperSnapper?

We'll blog when a new sensor is released - https://blog.adafruit.com/?s=wippersnapper