I am getting this error when I try to add the BMP280: Your I2C Component at address 0x77 could not initialize
The I2C scan finds the device at 0x77 and the bmp280test.ino example sketch works just fine.
Any suggestions are welcomed.
Huzzah32 I2C could not initialize
Moderators: adafruit_support_bill, adafruit
Forum rules
If you're posting code, please make sure your code does not include your Adafruit IO Active Key or WiFi network credentials.
If you're posting code, please make sure your code does not include your Adafruit IO Active Key or WiFi network credentials.
2 posts
• Page 1 of 1
Please be positive and constructive with your questions and comments.
Re: Huzzah32 I2C could not initialize
Hey! Unfortunately, the BMP280 is currently not supported in wippersnapper. You can find the full list of supported i2c sensors here: https://github.com/adafruit/Wippersnapp ... onents/i2c
Hope this answers your question.
Hope this answers your question.
-
eherrada - Posts: 161
- Joined: Thu Jan 04, 2018 4:59 pm
2 posts
• Page 1 of 1
Please be positive and constructive with your questions and comments.