hello should i use phone or mix out for the output of x0xb0x? phones out is cool for the headphones, but it seems too noisy for me mix out is not noisy, but i can't check it with my soundcard input as the card broken now
in my experience, they are both fine only that mix-out is mono (or is it my damn cables, who knows..)
We are here too:irc.freenode.net >>> #x0xb0x ..:: c0nb0x v1.00 ::.. http://forums.adafruit.com/viewtopic.php?f=7&t=29282 (new control app - win/osx) VCO Tuning: http://forums.adafruit.com/viewtopic.php?f=12&t=24759 (do it the EASY way)
I just read in another thread that it seems to be TS. I verified with a TS cable that it's significantly louder in my mixer using a TS cable over a TRS cable. Can this go into the manual?
Due to a questionable design decision the ring of the TRS MIX output jack is left open. So if you connect it with a TRS cable to a mixer with an symmetrical input, the "cold" part of input is open. Which works bad.
Solder a wire from ring to ground on the I/O board and the problem is gone.
(In a good design the "cold" (ring) gets the same output impedance as the "hot" (tip), such outputs are called pseudo symmetrical. They work perfectly together with all other studio gear. )