Hi there.
Has anyone any idea what might cause this issue?
This mode looped fine a few months back but I've been sequencing xox from Octatrack since then.
It's been lying idle since in normal temperature and was not damaged/dropped.
It loops fine in Pattern Edit mode but in Pattern (Midisync) mode the pattern plays once through the 16 steps and finish.
Things I've tried:
Switched midi cables.
Running midi from octatrack.
Running midi from interface.
Rebooting Xox.
Changing midi channels on xox.
Perhaps it needs to be completely reset. Not sure if that can be done though. Any tips would be much appreciated:)
Xoxbox not looping in Pattern (Midisync) mode?
Moderators: altitude, adafruit_support_bill, adafruit, phono, hamburgers
Please be positive and constructive with your questions and comments.
- Martinukai
- Posts: 20
- Joined: Fri May 15, 2015 11:22 pm
Please be positive and constructive with your questions and comments.