๐Ÿ“ฃ๐Ÿ“ช ๐Ÿšš Adafruit will not be shipping USPS orders Monday October 14, 2019 ๐Ÿ—“. Expedited USPS orders placed after 11am ET ๐Ÿ•š Friday October 11 will go out Tuesday October 15 ๐Ÿ“ฃ๐Ÿ“ช๐Ÿšš
0

Trouble selecting correct RFID module/antenna for a project
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

Trouble selecting correct RFID module/antenna for a project

by HeavyWings on Wed Jul 31, 2019 4:16 pm

Working on a project that requires multiple RFID tags to be read in close proximity to each other with a very short read range on the antenna, so using an ISO15693-compatible 13.56Mhz unit. Looking for modules that are Arduino compatible as it'll be connected a Feather m0 bluefruit LE. Module I picked up spur of the moment was an X-Nucleo-NFC03A1 which fits the bill for everything I want EXCEPT I would have to use an STM32 board and don't want to go that route due to other project requirements.

Any help and suggestions would be greatly appreciated!

HeavyWings
 
Posts: 3
Joined: Sat Jul 06, 2019 9:59 am

Re: Trouble selecting correct RFID module/antenna for a proj

by adafruit_support_mike on Fri Aug 02, 2019 1:18 am

I'm afraid we don't have anything that can read multiple tags. Maybe someone from the community will have more information.

In terms of connecting to a Feather, anything that has a Serial interface can probably be made to work.

adafruit_support_mike
 
Posts: 59116
Joined: Thu Feb 11, 2010 2:51 pm

Please be positive and constructive with your questions and comments.