Voting resources, early voting, and poll worker information - VOTE. ... Adafruit is open and shipping.
0

Need help with eink display
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

Need help with eink display

by momonga906 on Sun May 31, 2020 3:54 pm

I am new to the community. I am trying to tinker with an e-ink display.
I want to use analog sound/volume input to dynamically toggle through a set of images saved in an SD card (e.g. louder the sound bigger the image).
I need a bigger display than 2.9 so I ordered one from amazon. (https://www.amazon.com/dp/B07ZVK2YQV/ref=cm_sw_r_tw_dp_U_x_TrY0Eb1F6DH6R)

The product page for eink Feather friend with 32kb SRAM says it's for use with just about any E-Ink display that has a 24-pin FPC connector. But Adafruit EPD Library on Github does not seem to accommodate non-adafruit display?

I am lost where to start. Can somebody lead me to a tutorial?
Attachments
Capture.JPG
Capture.JPG (31.33 KiB) Viewed 57 times

momonga906
 
Posts: 2
Joined: Sat May 30, 2020 11:59 pm

Please be positive and constructive with your questions and comments.