I recently made my first PCB using a ATSAMD51J18A chip. It was mostly based on the Feather M4. There are a couple of different pins and of course the chip is different as well. I got myself a JLink EDU and installed the Microchip Studio. I want to make a custom bin file so that I can upload the bootloader to my board and use it with Arduino IDE. I modified the board.mk and board_config.h files of the Feather M4 and attached the config file to this post. Forum does not accept attaching mk files. How do I convert these to bin?
I followed these tutorials
https://learn.adafruit.com/how-to-progr ... s?view=all
https://www.hackster.io/wallarug/uf2-bo ... rds-c9620c
Any help would be appreciated.
Custom SAMD51 Board Help
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- Legocanavari
- Posts: 1
- Joined: Sun Jul 25, 2021 4:23 pm
Custom SAMD51 Board Help
- Attachments
-
- board_config.h
- (955 Bytes) Downloaded 13 times
Please be positive and constructive with your questions and comments.