How To Connect Perma-Proto Board To RPi 4?

General project help for Adafruit customers

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
NormanDee
 
Posts: 1
Joined: Tue Sep 14, 2021 3:54 pm

How To Connect Perma-Proto Board To RPi 4?

Post by NormanDee »

Hey there, I have what is likely to be a very simple and silly question, however, I'm quite new to all things RPi, breadboards, etc. And I just haven't had any luck finding an answer online for this question, so I was hoping someone on the forums could point me in the right direction?

Basically, I'm almost at the point in my project where everything's running great on the breadboard, and I'm almost ready to get that transferred over and soldered up to a perma-proto board.

However, my question is: How do I then connect that permanently soldered board, to the raspberry, so I can run my scripts?

Again, probably a silly question, but I thank you so much for helping me better understand this!

User avatar
adafruit_support_bill
 
Posts: 88037
Joined: Sat Feb 07, 2009 10:11 am

Re: How To Connect Perma-Proto Board To RPi 4?

Post by adafruit_support_bill »

We have a version especially for attaching to the Pi. One is a full-size HAT:
https://www.adafruit.com/product/2310
And a bonnet-sized one also:
https://www.adafruit.com/product/3203

Locked
Please be positive and constructive with your questions and comments.

Return to “General Project help”