I have this Lilygo TTGO T8 ESP32-S2 ST7789 flashed with CircuitPython 7.0.0-rc.1 and cannot reset in bootloader mode.
I first flashed it with CircuitPython 6.3.0 stable (according the first flash method on this page https://circuitpython.org/board/lilygo_ ... s2_st7789/)
and had no success to reset in bootloader mode either by:
- pressing twice the reboot button
or
- running this command:
Code: Select all
import microcontroller
microcontroller.on_next_reset(microcontroller.RunMode.BOOTLOADER)
microcontroller.reset()
Install, Repair, or Update UF2 Bootloader
I followed it, everything went fine. BTW congrats and thanks for the Adafruit Webserial Esptool: awesome!
At the end a boot drive appeared and I copied CircuitPython 7.0.0-rc.1 on it.
CircuitPython runs fine but I’m still not able to go to bootloader mode either by:
- pressing twice the reboot button
or
- running this command:
Code: Select all
import microcontroller
microcontroller.on_next_reset(microcontroller.RunMode.BOOTLOADER)
microcontroller.reset()
Do I have to manipulate the dip switch or anything else?
Thanks
--
Jmp0