Neopixel Friend Breakout Question

[zzcrow]

Do the both output headers on the neopixel friend breakout have 100 ohm resistors? I soldered the output closest to the rj-45 with riser header and was planing to use that one for my output. I tried using a multimeter to test conductivity between both output header pins once I soldered them, only to get a reading of 100 ohms between them. I am going to use long cables to go to the led strip, so I need the 100 ohm resistance. Does it have the resistance on both output headers or not? Thanks

[zzcrow]

UGH I think I figured this out by looking at the schematic... I'll just have to position my Neopixel Friend differently on my breadboard