is there any particular pin I need to assign in order for the Pro Trinket to power a speaker? Or can it at all? I know the Arduino Uno can on pins 9 and 10. Also, I am looking to do Multi-Mode as exampled here https://github.com/TMRh20/TMRpcm/blob/m ... _2Pins.ino
would this be possible with a ProTrinket 3.3v?
Pro Trinket speaker
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_mike
- Posts: 67446
- Joined: Thu Feb 11, 2010 2:51 pm
Re: Pro Trinket speaker
The Pro Trinket uses the same microcontroller as the Arduino Uno, so the code should port over without too much trouble.
Please be positive and constructive with your questions and comments.