After purchasing the Pi Cobbler (PID: 914) I have noticed that it has a lot of noise in the cable. I am not able to get good input readings when using the Pi Cobbler. My PIR sensor (PID: 189) that I have purchased from you does not register effectively when using the cobbler. If I touch the wires with my finger, it will trip my input reading. I believe that the cable is not properly shielded and when viewing the all I/O pins using a python script that I created, I can see that pins will jump from a high to low state on their own. When the cable is disconnected, everything reads fine. I have rechecked all of my solder joints and can not find anything even remotely close to being an issue. Again, I feel that it is a shielding issue. Any suggestions?