I purchased a self-assembly Data Logger Shield Kit a few months ago and have only gotten around to assembling it this week. The assembly went well, and the first trial for RTC was successful also. When I try CardInfo, the serial monitor is returning "SD Card Not Initialised". It does this whether there is an SD Card in there or not. I have tried two 4GB SD Cards, both source from Adafruit, and formatted both with SD Formatter V3.1, with no success.
I have continuity on the SD Card Holder pins I can test with multimeter, and the GND pins all match as they are supposed to.
I believe I assembled the board correctly - see video here http://www.youtube.com/watch?v=OlUvreFuPns
Has anyone got any ideas on where the problem can relate to?