Programming Gemma2

Post test messages here

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
SeanTH
 
Posts: 6
Joined: Tue Feb 09, 2016 5:42 pm

Programming Gemma2

Post by SeanTH »

Hello, I have downloaded Codebender, but cant get past the 4th step "testing the device". I keep getting an error message. What do I do now?

User avatar
adafruit_support_bill
 
Posts: 88037
Joined: Sat Feb 07, 2009 10:11 am

Re: Programming Gemma2

Post by adafruit_support_bill »

I keep getting an error message. What do I do now?
Error messages often tell you what the problem is or where to look for it. If you post the message here, we may be able to help.

User avatar
SeanTH
 
Posts: 6
Joined: Tue Feb 09, 2016 5:42 pm

Re: Programming Gemma2

Post by SeanTH »

No, there where no suggestions. I need help:(

User avatar
adafruit_support_bill
 
Posts: 88037
Joined: Sat Feb 07, 2009 10:11 am

Re: Programming Gemma2

Post by adafruit_support_bill »

We can't help unless you post the error messages. How else are we supposed to guess what is wrong?

User avatar
SeanTH
 
Posts: 6
Joined: Tue Feb 09, 2016 5:42 pm

Re: Programming Gemma2

Post by SeanTH »

Oh, sorry. Here you go...Getting Started Page 4 of 5
Testing the device
Almost there! Now we're going to run a basic sketch on your Arduino device.
Connect your device, select programmer and click on "Run on Arduino"
Run on Arduino
An error occurred while connecting to your device. Please try again.

User avatar
hiduino
 
Posts: 862
Joined: Sat Sep 01, 2012 7:05 pm

Re: Programming Gemma2

Post by hiduino »

The Codebender USB drivers do not work well with some programmer types like USBtinyISP on some computers. I would recommend using the Arduino IDE instead for the Gemma and Trinket boards.

Locked
Please be positive and constructive with your questions and comments.

Return to “Test Message Forum (closed)”