Programming Gemma2
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- SeanTH
- Posts: 6
- Joined: Tue Feb 09, 2016 5:42 pm
Programming Gemma2
Hello, I have downloaded Codebender, but cant get past the 4th step "testing the device". I keep getting an error message. What do I do now?
- adafruit_support_bill
- Posts: 88112
- Joined: Sat Feb 07, 2009 10:11 am
Re: Programming Gemma2
Error messages often tell you what the problem is or where to look for it. If you post the message here, we may be able to help.I keep getting an error message. What do I do now?
- SeanTH
- Posts: 6
- Joined: Tue Feb 09, 2016 5:42 pm
Re: Programming Gemma2
No, there where no suggestions. I need help:(
- adafruit_support_bill
- Posts: 88112
- Joined: Sat Feb 07, 2009 10:11 am
Re: Programming Gemma2
We can't help unless you post the error messages. How else are we supposed to guess what is wrong?
- SeanTH
- Posts: 6
- Joined: Tue Feb 09, 2016 5:42 pm
Re: Programming Gemma2
Oh, sorry. Here you go...Getting Started Page 4 of 5
Testing the device
Almost there! Now we're going to run a basic sketch on your Arduino device.
Connect your device, select programmer and click on "Run on Arduino"
Run on Arduino
An error occurred while connecting to your device. Please try again.
Testing the device
Almost there! Now we're going to run a basic sketch on your Arduino device.
Connect your device, select programmer and click on "Run on Arduino"
Run on Arduino
An error occurred while connecting to your device. Please try again.
- hiduino
- Posts: 862
- Joined: Sat Sep 01, 2012 7:05 pm
Re: Programming Gemma2
The Codebender USB drivers do not work well with some programmer types like USBtinyISP on some computers. I would recommend using the Arduino IDE instead for the Gemma and Trinket boards.
Please be positive and constructive with your questions and comments.