Newbie here. Downloaded IDE software to imac. Ran Arduino program and opened Blink program. When I plugged in the UNO, led 13 immediately lit up. Not sure why. Had not uploaded program yet. When I uploaded, got this error:
avrdude: stk500_recv(): programmer is not responding
Any suggestions as to where I am going wrong
problem with blink program
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- Franklin97355
- Posts: 23912
- Joined: Mon Apr 21, 2008 2:33 pm
Re: problem with blink program
What port did the Uno connect to? Are you sure you are using a data cable as opposed to a charging cable?
- thosbryan
- Posts: 11
- Joined: Sun May 21, 2017 3:58 pm
Re: problem with blink program
Gotta work on this a bit more. Had not yet wired up the board when I tried to upload the program. Will get back if I can’t figure it out. Thanks.
Please be positive and constructive with your questions and comments.