Hi
The connection between the GPS Board and a uFL to SMA cable (which connects to an antenna) seems a bit insecure to me. Could I solder this on or would this cause issues?
Thanks
Can I solder on a uFL connector to the GPS Shield?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- tom1989
- Posts: 23
- Joined: Sun Apr 19, 2015 4:25 am
- devinganger
- Posts: 72
- Joined: Tue Aug 09, 2016 1:09 am
Re: Can I solder on a uFL connector to the GPS Shield?
Would not recommend it. That's two contacts, if I'm looking at it correctly. If you set up the proper strain relief and press down firmly, it should be fine.
Please be positive and constructive with your questions and comments.