Hi there, I’m almost done with my first x0xb0x! Pretty exciting! I’ve completed the first couple of tests but now I’m stuck on testing the Envelope.
I’ve connected an alligator clip between the south side of R146 and R3 but when I test the north side of D35 I’m only getting about 6.2v when it should be 12v.
Is there anything obvious I should be looking at here? Sorry I’m a novice when it comes to reading schematics etc. any help would be massively appreciated!
Envelope Testing getting incorrect voltage
Moderators: altitude, adafruit_support_bill, adafruit, phono, hamburgers
Please be positive and constructive with your questions and comments.
- knobToucher
- Posts: 4
- Joined: Sun May 05, 2019 5:15 am
Please be positive and constructive with your questions and comments.