Title says it all, actually.
Is there a quick and convenient way to do a total wipe and factory reset on this unit? I googled (actually DDG) and tried to find anything in TFM and it is not obvious.
I have several of these units (both pink and plain-jane), and one of them is getting increasingly flaky, after bouncing between Arduino and CircuitPython several times, with corrupt files and such.
I would like to just do a clean factory reset on this.
Is this possible?
Thanks
Adafruit Feather RP2040 factory reset?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_carter
- Posts: 29056
- Joined: Tue Nov 29, 2016 2:45 pm
Re: Adafruit Feather RP2040 factory reset?
The factory shipped firmware is available here:
https://learn.adafruit.com/adafruit-fea ... /downloads
Put the board in bootloader mode and drag the UF2 to the RPI-RP2 folder.
This may not fully clean up the entire flash storage though. Another option is to try storage erase from CircuitPython:
https://learn.adafruit.com/welcome-to-c ... em-2987288
https://learn.adafruit.com/adafruit-fea ... /downloads
Put the board in bootloader mode and drag the UF2 to the RPI-RP2 folder.
This may not fully clean up the entire flash storage though. Another option is to try storage erase from CircuitPython:
https://learn.adafruit.com/welcome-to-c ... em-2987288
- jwinslade
- Posts: 44
- Joined: Fri May 21, 2021 12:00 pm
Please be positive and constructive with your questions and comments.