Hi,
I was wondering if anyone has experience with the Black Magic Probe to copy/load firmware and specifically whether it will work with the Adafruit NeoTrellis board which has a Seesaw with SAMD09 chip on it.
https://github.com/blackmagic-debug/blackmagic/releases
Stable Release 1.8.0 lists the Microchip SAMD09 as a supported target for BMD (Black Magic Debug), but does that means it also can load the firmware?
I’ve just ordered one anyway and will find out soon enough but if anyone has experience with it, any tips would be appreciated.
Thanks!
Black Magic Probe JTAG/SWD, work with SAMD09 ?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_mike
- Posts: 67446
- Joined: Thu Feb 11, 2010 2:51 pm
Re: Black Magic Probe JTAG/SWD, work with SAMD09 ?
Yes, that should work.
The SAMD09 is a Cortex M0+ chip, which is one of the generic platforms the Black Magic Probe supports.
The SAMD09 is a Cortex M0+ chip, which is one of the generic platforms the Black Magic Probe supports.
- meu
- Posts: 16
- Joined: Mon Jun 17, 2013 6:47 pm
Please be positive and constructive with your questions and comments.