Recommended Connector

General project help for Adafruit customers

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
flavinny
 
Posts: 4
Joined: Fri Jul 29, 2022 4:12 pm

Recommended Connector

Post by flavinny »

I intend to build a three-phase rectifier using a Protoboard diodes etc. purchased here. I need connectors on the board that would allow me to connect and disconnect the three input wires and the two output wires. Slip on type connectors would be preferred but screw clamp type would work.
Part numbers would be appreciated.

User avatar
adafruit_support_mike
 
Posts: 67446
Joined: Thu Feb 11, 2010 2:51 pm

Re: Recommended Connector

Post by adafruit_support_mike »

What voltage and current levels will you be using?

"Three-phase" usually means 240V-per-phase and industrial currents in the tens of amps. A prototyping board can't survive that much power.

Locked
Please be positive and constructive with your questions and comments.

Return to “General Project help”