Hello,
There is surprisingly very little info about this soldering iron stand: https://www.adafruit.com/product/150
On this product, I'm trying to figure out the inner diameter of the tube that the soldering tip fits through, because I've purchased two other stands on Amazon and they are all too big. I have a "pen style" handle, and the flared out section just behind the tip is 16mm at the widest point.
Soldering iron stand in the Adafruit store
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- nix_clk_dd
- Posts: 38
- Joined: Tue May 21, 2019 2:15 pm
- mikeysklar
- Posts: 13945
- Joined: Mon Aug 01, 2016 8:10 pm
Re: Soldering iron stand in the Adafruit store
The product photos show this to be an ATTEN S-11 solder stand. There is a little bit of info on page 37, 38 (PDF numbers them 34-35). Replace BANNED with ATTEN for the URL.
https://www.BANNED/product/s_11_solder_stand
It is not specific about dimension for the stand, but it does show more specs about their compatible irons which could be helpful.
https://www.BANNED/product/s_11_solder_stand
It is not specific about dimension for the stand, but it does show more specs about their compatible irons which could be helpful.
- adafruit_support_carter
- Posts: 29189
- Joined: Tue Nov 29, 2016 2:45 pm
Re: Soldering iron stand in the Adafruit store
Grabbed one from stock and did a quick measurement.
Please be positive and constructive with your questions and comments.