I would like to make use of the Raspberry Pi PoE+ Hat you sell.
https://www.adafruit.com/product/5058
However, I need to add a few sensors from your Stemma QT lineup. Temp, humidity, light sensor, and sound.
I am not familiar with the low profile SMD headers on the Hat. Can I add additional things on top of the Hat? Under the Hat? I can't quite tell if they are through hole, etc. Maybe I need a special breakout or prototype board instead?
Or, does this Hat prevent anything further from being added above or below?
Thank you for your help!
Add Other things to Raspberry Pi PoE+ Hat?
Moderators: adafruit_support_bill, adafruit
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
- CaseyScalf
- Posts: 149
- Joined: Wed Nov 05, 2014 3:07 am
- mikeysklar
- Posts: 13824
- Joined: Mon Aug 01, 2016 8:10 pm
Re: Add Other things to Raspberry Pi PoE+ Hat?
You can stack the Pi PoE+ Hat with stacking headers to connect other devices.
https://www.adafruit.com/product/1979
https://www.adafruit.com/product/1979
- CaseyScalf
- Posts: 149
- Joined: Wed Nov 05, 2014 3:07 am
Re: Add Other things to Raspberry Pi PoE+ Hat?
Absolutely magical you all have thought of everything. Thank you!
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/