Debug

Hand tools, soldering irons, scopes, multimeters. Talk about em HERE!

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
Bipman
 
Posts: 12
Joined: Wed Jan 11, 2023 6:29 pm

Debug

Post by Bipman »

Hi

I think this is the correct forum! I'm a relative beginner with micro controllers and it's all coming together now. As my code becomes more complex, I'm in need of a debugger device. I've looked into the J-TAG connecter etc. and it's all either a bit confusing or very expensive (or both). Could someone point me in the right direction?

Bipman

User avatar
dastels
 
Posts: 12792
Joined: Tue Oct 20, 2015 3:22 pm

Re: Debug

Post by dastels »

What hardware and programming language are you using?

Dave

User avatar
Bipman
 
Posts: 12
Joined: Wed Jan 11, 2023 6:29 pm

Re: Debug

Post by Bipman »

That would be an Arduino Nano IOT 33 and the Arduino IDE. Then again I also have some sparkfun microboards that I may use. I suppose it matters what chip they use.

Bipman

User avatar
dastels
 
Posts: 12792
Joined: Tue Oct 20, 2015 3:22 pm

Re: Debug

Post by dastels »

Yes, the MCU will have an impact on what you need.

This (https://www.adafruit.com/product/3839) is a nice looking bit of debugging hardware if it supports your MCU/board. It make the setup easier.

Dave

User avatar
Bipman
 
Posts: 12
Joined: Wed Jan 11, 2023 6:29 pm

Re: Debug

Post by Bipman »

OK, thanks. I'll take a look

Bipman

Locked
Please be positive and constructive with your questions and comments.

Return to “Tools Tools Tools”