I want to use Macropad as a training tool for a group at work, but for security reasons we are not able to access any USB drive that is not bitlocked. is it possible to upload code from the Arduino ide or VSCode or Mu using a serial protocol insetad? If so, how?
This is a show stopper ...
PS. Probably some of the participants will be on macs, others on Windows 10.
Program Macropad other than as USB drive
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- NigelWGMajor
- Posts: 1
- Joined: Sat May 23, 2015 12:45 pm
- mikeysklar
- Posts: 13936
- Joined: Mon Aug 01, 2016 8:10 pm
Re: Program Macropad other than as USB drive
When uploading Arduino code to the MacroPad a USB mount should not be necessary as it is for CircuitPython.
Are you able to put the board into bootloader mode (boot button + reset) and upload code from the Arduino IDE? It is going through a port.
https://learn.adafruit.com/adafruit-mac ... ch-3107266
Are you able to put the board into bootloader mode (boot button + reset) and upload code from the Arduino IDE? It is going through a port.
https://learn.adafruit.com/adafruit-mac ... ch-3107266
Please be positive and constructive with your questions and comments.