Gemma M0 not getting any power

Wearable electronics: boards, conductive materials, and projects from Adafruit!

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
ChaoticKitsu
 
Posts: 6
Joined: Sat Mar 18, 2023 12:42 am

Gemma M0 not getting any power

Post by ChaoticKitsu »

Finally tested out a recent Gemma M0 that I ordered off Adafruit, but I don't get any power or response what so ever. The LED next to the reset button doesn't cut on under any circumstance; not when the usb is plugged in, the reset button is pressed/ double pressed, the switch being cut on and off, or with a battery hooked up to it. I referenced to an older post to see if there was any way to troubleshoot it, with no luck. I also should note that there are indentations around the edge of the Gemma as well.

Any help is greatly appreciated; thanks in advance

User avatar
adafruit_support_carter
 
Posts: 29167
Joined: Tue Nov 29, 2016 2:45 pm

Re: Gemma M0 not getting any power

Post by adafruit_support_carter »

When was this ordered?

If you still have the little bag it came in with the barcode sticker on it, can you post a photo of that.

User avatar
ChaoticKitsu
 
Posts: 6
Joined: Sat Mar 18, 2023 12:42 am

Re: Gemma M0 not getting any power

Post by ChaoticKitsu »

It was ordered around the 10th of April.
Attachments
PXL_20230504_011954176.MP.jpg
PXL_20230504_011954176.MP.jpg (243.97 KiB) Viewed 822 times

User avatar
adafruit_support_carter
 
Posts: 29167
Joined: Tue Nov 29, 2016 2:45 pm

Re: Gemma M0 not getting any power

Post by adafruit_support_carter »

Thank you very much for the photo. Based on the behavior you described, I think we should just replace this one.

Send an email to [email protected] with a link to this thread and your order number and they can send you a replacement Gemma M0.

Locked
Please be positive and constructive with your questions and comments.

Return to “Wearables”