SHT41 After-Solder Care: Re-Hydrating

Chat about pick and place machines, reflow ovens, assembly techniques and other SMT tips & trix

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
DestinationSPACE
 
Posts: 1
Joined: Thu Sep 14, 2023 9:09 am

SHT41 After-Solder Care: Re-Hydrating

Post by DestinationSPACE »

I was looking through the "Sensor Specification Statement and Testing Guide" application note from Sensirion and saw something about "re-hydrating" the sensor after soldering for 48 hours in >74%RH at 20-30C (2.1.c). I was wondering if this was something done for the 5776 breakout boards? Also, I was wondering if you all have done any side-by-side comparisons between ones that have been "re-hydrated" and ones that were only reflowed? I am trying to figure out if this is something I need to consider for my weather station boards, or if you all have determined that the accuracy is good enough to not warrant this extra step, at least for general use.


Thank you,

Destination SPACE Inc.

User avatar
adafruit_support_mike
 
Posts: 67339
Joined: Thu Feb 11, 2010 2:51 pm

Re: SHT41 After-Solder Care: Re-Hydrating

Post by adafruit_support_mike »

If you want reliable measurements from any sensor, you have to perform at least a basic calibration:

https://learn.adafruit.com/calibrating-sensors

Drying and rehydration are processes for correcting offsets you find during calibration. We don't find them necessary in general, and there's no way to guarantee anything we do will stand up to conditions during shipping or in the operating environment.

Locked
Please be positive and constructive with your questions and comments.

Return to “SMT (Surface Mount Tech)”