Firstly I'm sorry to open a second topic within a few days. I went through dozens of topics with no solution. :(
Here's my problem: I finished building the VCA. Unfortunately there is zero output if I do the headphone test to hear the "struck note".
What seems strange are the DC bias on the BA662A (BA662 Clown openmusiclabs) :
pin1 = 120mV
pin2 = 5.33V
pin3 = 5.33V
pin4 = 11.9V
pin5 = 0.5mV
pin6 = 5.25V
pin7 = 5.25V
pin8 = 5.3V
pin9 = 11.9V
If I'm not mistaken, only pin 2 and 3 are exchanged in comparison to the BA6110.
I already checked twice for any solder bridges, but didn't find anything.
(Yes, I soldered it on IC15A and omitted Q1/Q2/Q3/Q4)
Thank you for your help.
Very wrong voltages on BA662
Moderators: altitude, adafruit_support_bill, adafruit, phono, hamburgers
Please be positive and constructive with your questions and comments.
- Faye_108
- Posts: 4
- Joined: Wed Oct 30, 2019 11:02 am
Re: Very wrong voltages on BA662
It seems that the BA662 was faulty.
Out of pure desperation I desoldered it and replaced it by a BA6110 that I had at hand. Luckily on the BA6110 all voltages were normal.
Thank you for your time.
Out of pure desperation I desoldered it and replaced it by a BA6110 that I had at hand. Luckily on the BA6110 all voltages were normal.
Thank you for your time.
Please be positive and constructive with your questions and comments.