Hi there, I recently purchased a USBtinyISP kit from jameco and it was missing one of the 3.6v Zener diodes. I have a 3.3v one and was wondering if I could use that instead of ordering and waiting etc.
Thank you!
Swap Zener 3.3v for 3.6v ok?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- dastels
- Posts: 15608
- Joined: Tue Oct 20, 2015 3:22 pm
Re: Swap Zener 3.3v for 3.6v ok?
Impossible to know without knowing what it's doing in the circuit, but without that I would say no... it's 3.6v for a reason.
Dave
Dave
- marshaj847
- Posts: 43
- Joined: Wed Jul 31, 2013 6:12 pm
Re: Swap Zener 3.3v for 3.6v ok?
looking at a schematic https://cdn-learn.adafruit.com/assets/a ... sp2sch.png
D1 and D2 seem to be voltage clamping on the USB data lines...
while it might not be a problem for short term use, since the USB programming cable is short, a long cable might have signal degradation issues mentioned in this posting
https://electronics.stackexchange.com/q ... -high-3-3v
Marsha
D1 and D2 seem to be voltage clamping on the USB data lines...
while it might not be a problem for short term use, since the USB programming cable is short, a long cable might have signal degradation issues mentioned in this posting
https://electronics.stackexchange.com/q ... -high-3-3v
Marsha
Please be positive and constructive with your questions and comments.