MintyComm download?
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 15
- Joined: Thu May 19, 2005 7:21 pm
i'm not sure if this will help you, but:
in my case, the usb was recognized, but a couple of the pins were not connected correctly. i can only assume that means that the a couple of the pins are necessary for communication but not for detection.
you should also check the frequencies of your crystals. also, the inductor bead is not listed in the directions as a part needed for the USB system, but it is in the schematic. have you soldered that in?
as a last check, I like to go in with a multimeter and check for connectivity between places that should be connected (i.e. each pin on the PIC and its end point. for example, pin 24 and 25 on the FTDI chip (RX,TX) and pin 43 & 44 on the PIC). Go through each connection used in the necessary system and ensure connectivity.
in my case, the usb was recognized, but a couple of the pins were not connected correctly. i can only assume that means that the a couple of the pins are necessary for communication but not for detection.
you should also check the frequencies of your crystals. also, the inductor bead is not listed in the directions as a part needed for the USB system, but it is in the schematic. have you soldered that in?
as a last check, I like to go in with a multimeter and check for connectivity between places that should be connected (i.e. each pin on the PIC and its end point. for example, pin 24 and 25 on the FTDI chip (RX,TX) and pin 43 & 44 on the PIC). Go through each connection used in the necessary system and ensure connectivity.
-
- Posts: 24
- Joined: Wed Apr 27, 2005 1:00 pm
-
- Posts: 24
- Joined: Wed Apr 27, 2005 1:00 pm
i've tried it in both positions. also tried hitting "write flash" and then toggling the switch both ways. I'm building two minty's at the same time. i was able to get it to program one now. the only difference was i had the battery hooked up to that one. then i was able to open hyper terminal and get it to spit out garbage once, but now nothing (and i tried the two different speeds in hyperterminal. should the other hyper terminal settings be changed? i assume flow control should be none.)
-
- Posts: 42
- Joined: Tue May 10, 2005 2:12 pm
Please be positive and constructive with your questions and comments.