I'm following the guide for No-Code IoT Humidity and Temperature Sensor with Adafruit.io WipperSnapper guide and have (after reloading the bootloader on the Feather) gotten stuck trying to set up the AHT20. I am using the Adafruit ESP32-S2 Feather - 2 MB PSRAM and STEMMA QT / Qwiic, the feather-esp32-s2-factory-reset-and-bootloader.bin bootloader file, and the wippersnapper.feather_s2_tinyusb.1.0.0-beta.22.uf2. The Feather successfully appears on my account, but I cannot get the sensor to register. No other devices are attached to the Feather and I have a green light on the AHT20.
At issue seems to to be the I2C address of the sensor. Here is the address detected.
Here is the error message.
I do not see anything in the documentation about re-configuring the device I2C address, so I assume that is impossible.
Where do I go from here?
AHT20 and Wippersnapper
Moderators: adafruit_support_bill, adafruit
Forum rules
If you're posting code, please make sure your code does not include your Adafruit IO Active Key or WiFi network credentials.
If you're posting code, please make sure your code does not include your Adafruit IO Active Key or WiFi network credentials.
- michimac
- Posts: 8
- Joined: Sun Jan 23, 2022 12:04 pm
Re: AHT20 and Wippersnapper
Must have been a bad connection in the JST cable. After beating my head against a wall and reflashing and digging and rechecking everything for several hours, out of desperation I took the JST terminated cable off and checked the pins, flipped the cable end for end, and plugged everything back in. For absolutely no apparent reason, it worked. I must have finally said the right word.
Forum rules
If you're posting code, please make sure your code does not include your Adafruit IO Active Key or WiFi network credentials.
If you're posting code, please make sure your code does not include your Adafruit IO Active Key or WiFi network credentials.