Hi,
I get false presses on rotation using the supplied example code.
I saw a note about not pressing the back of the switch while operating.
I am not touching the rear of the PCB.
Any remedy out there?
seesaw rotary encoder false presses on rotation
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- mkeesling
- Posts: 1
- Joined: Tue Oct 11, 2022 10:09 pm
- adafruit_support_carter
- Posts: 29056
- Joined: Tue Nov 29, 2016 2:45 pm
Re: seesaw rotary encoder false presses on rotation
Just to verify, you are using one of these?
https://www.adafruit.com/product/4991
What encoder are you using? Is it this one?
https://www.adafruit.com/product/377
Is the encoder soldered to the breakout?
https://www.adafruit.com/product/4991
What encoder are you using? Is it this one?
https://www.adafruit.com/product/377
Is the encoder soldered to the breakout?
Please be positive and constructive with your questions and comments.