Making connection to 16 Ch servo bonnet GPIO
Moderators: adafruit_support_bill, adafruit
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
- cm001
- Posts: 2
- Joined: Sun Nov 27, 2022 10:34 pm
Making connection to 16 Ch servo bonnet GPIO
What is the suggested way to connect to the GPIO holes on the Adafruit 16 ch servo bonnet? Is there a header that can be soldered into these holes so male or female pin connections can be made? Thank you.
- adafruit_support_bill
- Posts: 88154
- Joined: Sat Feb 07, 2009 10:11 am
Re: Making connection to 16 Ch servo bonnet GPIO
These have a 0.1" pin spacing, so any 0.1" pitch headers will fit. The male 'breakaway' header strips will snap apart to any length. The female strips can also be cut to length, but you lose one pin in the process.
https://www.adafruit.com/product/4154
https://www.adafruit.com/product/598
https://www.adafruit.com/product/4154
https://www.adafruit.com/product/598
- cm001
- Posts: 2
- Joined: Sun Nov 27, 2022 10:34 pm
Re: Making connection to 16 Ch servo bonnet GPIO
Excellent! Thank you.
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/