Hello,
I was wondering if anyone can help or has also had this issue with the Magic Band Reader Tutorial using the Adafruit Feather RP2040. I ran into an issue where when I plug in the USB on the Feather RP2040, the lights will spin and the audio clips will continue to play. I noticed that if I scan my RFID tag it will pause the lights and the sound but then continue again.
All of my wiring matches the tutorial and I looked through the python code but the only mistake I could see was that the pixel number was set to 24 instead of 31. I corrected that part to use all of the LEDs in my project but I do not see anything that I could change in the code to correct the issue I am having. Is there an issue in the Libraries?
Has anyone else had this issue and if so, were you able to correct it? Thanks!
Magic Band Reader Tutorial - Constantly playing until RFID scanned
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- outletpro
- Posts: 3
- Joined: Fri Dec 02, 2022 2:16 pm
- dastels
- Posts: 15831
- Joined: Tue Oct 20, 2015 3:22 pm
Re: Magic Band Reader Tutorial - Constantly playing until RFID scanned
Check my response to the other post about this (that you also commented on).
Dave
Dave
Please be positive and constructive with your questions and comments.