I'm collecting a whole lot of parts - wires, resistors, switches, etc - including quite a few Adafruit breakout sensor boards and microcontrollers..... and I was wondering what people use to store all this good stuff in? I have a couple Stanley parts cases that seem to be OK, but maybe there's something better.
What do you use?
Do I need to worry about static? About parts bumping into each other (I don't think so, maybe).
Ideas appreciated!
/rob in Seattle
Component & breakout storage
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- dastels
- Posts: 15699
- Joined: Tue Oct 20, 2015 3:22 pm
Re: Component & breakout storage
I have an assortment of Akro-Mils drawer units, single and double width drawers. I've never had any problem with them.
Dave
Dave
- adafruit_support_mike
- Posts: 67459
- Joined: Thu Feb 11, 2010 2:51 pm
Re: Component & breakout storage
Fishing tackle boxes are also good, and easy to find.
For components, I mostly use SMT parts. Test tubes work well for those:
For components, I mostly use SMT parts. Test tubes work well for those:
Please be positive and constructive with your questions and comments.