- Ran WifiScan and WifiClientConnect example on both Qt Pys, as well as another Lolin C3 Pico I had laying around. Both "good" boards connected to my router right away. (So it's probably not the router?)
- Ran through the Qt Py esp32-c3 tutorial with the "bad" qt py. I was able to get in and out of bootloader mode, as well as flash the built-in Neopixel (so I didn't wedge the chip?)
- Tried WifiScan/other Wifi examples on the "bad" board with reduced frequency (80Mhz vs 160Mhz), and also tried disabling Wifi 6 features on the router. No change.
Is there maybe something I'm missing here? Is it possible to wedge an esp32 so it can only do RX for WiFi? Or did I just get unlucky with the chip I got?