Using an arduino as a ISP dongle

SpokePOV kit for bikes

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
yincrash
 
Posts: 4
Joined: Sun Apr 27, 2014 9:00 pm

Using an arduino as a ISP dongle

Post by yincrash »

I attempted to make an ArduinoISP with the attiny2313 chip on a breadboard, then use the SpokePOV software (on Windows) to connect with it. It made the ISP status LEDs blink, but errored out. Is this not really supported by the SpokePOV software because there is something different about the USBtinyISP?
Last edited by yincrash on Sun Apr 27, 2014 10:35 pm, edited 1 time in total.

yincrash
 
Posts: 4
Joined: Sun Apr 27, 2014 9:00 pm

Re: Using an arduino as a ISP dongle

Post by yincrash »

Hmm. Would it work if I just put 1.5K resistors on the SCK and MOSI line of the ArduinoISP then used a 10pin header to connect it to the board?

Locked
Please be positive and constructive with your questions and comments.

Return to “SpokePOV (discontinued)”